Event
Ph.D. Dissertation Defense: David Bowen
Wednesday, April 13, 2011
2:30 p.m.
Room 2328, AVW Bldg.
Maria Hoo
301 405 3681
mch@umd.edu
ANNOUNCEMENT: Ph.D. Dissertation Defense
Name: David Bowen
Committee:
Professor Isaak D. Mayergoyz, Chair
Professor Reza Ghodssi
Professor Thomas E. Murphy
Professor Robert Newcomb
Professor Mario Dagenais
Professor A. Udaya Shankar, Dean‟s Representative
Date/Time: 2:30 pm on Wednesday, April 13th, 2011
Location: A.V. Williams 2328 Conference Room
Title: MODELING AND TESTING OF ETHERNET TRANSFORMERS
Abstract:
Twisted-pair Ethernet is now the standard home and office last-mile network technology. For decades, the IEEE standard that defines Ethernet has required electrical isolation between the twisted pair cable and the Ethernet device. So, for decades, every Ethernet interface has used magnetic core Ethernet transformers to isolate Ethernet devices and keep users safe in the event of a potentially dangerous fault on the network media. The current state-of-the-art Ethernet transformers are miniature (<5mm diameter) ferrite-core toroids wrapped with approximately 10 to 30 turns of wire. As small as current Ethernet transformers are, they still limit further Ethernet device miniaturization and require a separate bulky package or jack housing. New coupler designs must be explored which are capable of exceptional miniaturization or on-chip fabrication.
This dissertation thoroughly explores the performance of the current commercial Ethernet transformers to both increase understanding of the device's behavior and outline performance parameters for replacement devices. Lumped element and distributed circuit models are derived; testing schemes are developed and used to extract model parameters from commercial Ethernet devices. Transfer relation measurements of the commercial Ethernet transformers are compared against the model's behavior and it is found that the tuned, distributed models produce the best transfer relation match to the measured data.
Process descriptions and testing results on fabricated thin-film dielectric-core toroid transformers are presented. The best results were found for a 32-turn transformer loaded with 100Ω, the impedance of twisted pair cable. This transformer gave a flat response from about 10MHz to 40MHz with a height of approximately 0.45. For the fabricated transformer structures, theoretical methods to determine resistance, capacitance and inductance are presented. A special analytical and numerical analysis of the fabricated transformer inductance is presented. Planar cuts of magnetic slope fields around the dielectric-core toroid are shown that describe the effect of core height and winding density on flux uniformity without a magnetic core.
